大家在查：滚珠丝杠副过盈配合联接谐波传动机械零件设计手册车床主轴合模力多浇口模具型腔铸造斜度注塑成型机

拔模斜度

na.【冶】pattern draft
网络draft angle; Draft; Angular clearance

拔模斜度

拔模斜度

英-汉网络释义

拔模斜度

na.

1.【冶】pattern draft

1

The forging die has no draft angle and the material utilization rate is increased about 12 . 5%.

该模具结构使锻件的外形略去拔模斜度，材料利用率提高约 12 .

2

This is facilitated by designing a draft , a slight angular offset from the vertical to the vertical surfaces of the pattern .

这可以通过设计一个拔模斜度，使它与模型的垂直面之间有一个小小的角度偏移量，便可容易地实现。

3

4 parting line edges, flash, gates, runner, and riser extensions to be 0 . 10 maximum .

分型面、飞边、浇口、浇道以及拔模斜度不超过 0 .

4

Enter a sweep distance of 0 . 9 mm and a draft angle of 4 degrees.

输入打扫距离 0.9 毫米和 4 度拔模斜度。

5

This can make complex shaped castings without any draft or flash.

它能制造没有拔模斜度和缝脊的复杂形状铸件。

6

Study on the law of influence of drafting angle on upset-extruding

镦挤拔模斜度对成形的影响规律研究

热词推荐

大家在看